The Wilson Pickup System for violin has quite a few assets to offer:

• It gives a realistic, close to perfect, acoustic sound.
• It allows volume adjusting of bright and deep strings by simply rotating the Pick-up in its mount.
• It is accurate and completely linear in all registers.
• It has the same effect when played by pizz and arco.
• It is connected directly to an amplifier. No pre-amp needed.
• It is easily built into the bridge as an active part of the violin itself.
• It's position in the bridge is mixing a perfect balance between the output from your strings. A feature not covered by any competitor.
• It has a frequency response of 150 Hz to 30 kHz - and even beyond.

The craftmanship of the Wilson Pickups is uncompromised. Each Pickup is handmade in Denmark and thoroughly tested for mechanical tolerance, insulating resistance and frequency response.

Code:               V1-V2

Size:                 3,5* x 6,5 mm

Frequency:    150-30.000 Hz

Chord:             15 cm

Connection Jax: Switchcraft 121 (0.25"/6.35mm)

*) Tolerance +/- 0,01mm